Home > Printer Error > 54.2 Error Printer

54.2 Error Printer

Contents

If any are missing or dislodged you will need to replace/reseat them. It looked like a light switch sort of, and it looked like it was already in the position close to me. I then vacuumed out all the toner inside the printer. Took out every tray, blew compressed air all over the printer, inside and out. his comment is here

We do not sell these spare parts.We help you to create your parts sheets to request from your suppliers. Mag-sign in Ibahagi Higit pa I-ulat Kailangan mo bang iulat ang video? A connection block for the cable connector runs below the fan on the rear right side corner. When the printer is ready, the control panel will prompt for installation of the cartridges.Install each cartridge.After installing the fourth cartridge, press GO on the control panel.Error 54.2 appears again after http://h30434.www3.hp.com/t5/LaserJet-Printing/My-HP-LaserJet-100-color-MFP-M175nw-is-getting-a-54-2-error/td-p/2973757

54.2 Hp Printer Error

Thank you for requesting callback, we will get back to you soon. Have power cycled it 4 or 5 times, no help. I do like to watch it no matter what I'm printing, just in case.

Turn the printer off, then on.If you continue to get this message, contact HP."OP: MAC OS 10.8.4Any help appreciated,Galloglass Reply 0 0 pcwizard Provost Posts: 12,147 Member Since: ‎12-31-2009 Message 4 If PS10 is functioning properly, the binary value should switch between 0 and 1.NOTE: If the value does not toggle between 0 and 1, replace PS10.The cable connector (see Figure 3) Repeat this process to remove each remaining print cartridge.6. 54.2 Kg Convert Pounds Verify the brake is not preventing the carousel from turning.

I have done this but the printer still states intermittently Printer failure...."here is a problem with the printer or ink system. 54.2 Printer Error Hp 4550 by unknown on Jun 30, 2007 at 6:17am Add comment Please sign in to comment 0 Okay, I tried all this. A bunch of broken parts, etc, so I took the thing home and got a new carousel for it and installed it. http://h30434.www3.hp.com/t5/LaserJet-Printing/54-2-Error-on-HP-MFP-M175NW/td-p/1297299 Any ideas??????

does this mean anything?thanks,RG by Anonymous on Jul 25, 2007 at 3:42pm Add comment Please sign in to comment 0 I thought I remember reading that the sensor was supposed to 54.2 Error Hp 2840 by unknown on Jan 21, 2009 at 9:22am Add comment Please sign in to comment 0 Âñåì äîáðûé äåíü! Âàøè ðàññóæäåíèÿ çàñòàâèëè îáðàòèòü âíèìàíèå íà êàðóñåëü. Âíóòðåííÿÿ ÷àñòü òóãî âðàùàëàñü- çàäåâàëè Toner cartridge position within the carousel is monitored by PS11.If PS11 fails or is improperly connected, a 54.2 erroris displayed. Name: * Phone Number: * Email: * Message: *

--> PrintCopy .infoservice Service manual Parts List Error Code Equivalency Sign In Contacts About Us Service manual Error

54.2 Printer Error Hp 4550

the 54.2 Error is tellin' ya' its "TIRED".Good Luck and REPLACE IT!! To place the spring in the correct position, perform the following steps:Manually rotate the cam counter clockwise.Replace the bronze grounding spring, if damaged.Carousel sensor PS10 may not be working properly. 54.2 Hp Printer Error Diagnostic & repair for your technologies. 54.2 Carousel Error But still get the 54.2 error.

The carousel was off position. this content It started during the start-up and initialization : 54.2 error code , and memory problems . next question: if you install and/or remove the toners, did you use the printer menu and keybad? I think I was able to get the cartridges out without touching the roller.Was so glad I had to stop and say thanks! 54.2 Printer Error Cycle Power To Continue

by unknown on Jul 2, 2007 at 5:20am Add comment Please sign in to comment 0 other question: if you release the caroussel brake, and try to turn the caroussel manually, This printer is for a mobile van. It seems to me if you used enough force, you'd hear some awful noises. weblink It seemed to install fine but then an error message came up saying that black toner was not installed correctly.

Mag-sign in Transcript Mga Istatistika 88,281 (na) panonood 66 Gusto mo ba ang video na ito? Hp Laserjet 100 Color Mfp M175nw Error 49 longlifeprinters9 33,115 (na) panonood 1:02 HP Color Laserjet 2840 Toner Wechsel exchange und Reinigung cleaning - Tagal: 5:18. I also cleaned and blew air through most of the inside area and also removed, cleaned, and reinstalled the toner cartridges...wound up still getting the 54.2 error on restart.

Once in fifty powers on of printer start without error.

The printer runs through it's routine and error's out at the very last minute just before the "Ready" status should take place. Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, This appears to be what is halting the carousel movement in the backwards direction.Any ideas? Hp 2840 Service Manual Victor Sun 75,927 (na) panonood 6:40 Fixing a Paper Jam - HP LaserJet Pro CP1025nw Color Printer - Tagal: 6:25.

Anyhow, thanks again! To enter Diagnostic Mode, follow the instructions below:NOTE: The printer will not indicate if any doors are open while in Diagnostics mode. Forum contributers suggest I clean the three carousel sensors. check over here If anyone out there in this forum lives near Detroit MI I would like to meet up with you and perhaps we share notes and go on the 4550 learning curve

Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, Inspect the problem cartridge for damage (compare it to one of the other cartridges if necessary).7. built to last as opposed to built to sell cheaply), so why spend $300 on a printer that will more than likely need to be replaced within a few years? NVRAM settings may be lost.

Remove and reinstall the cartridges The removal and resetting of the cartridges upon the HP printers should be done with the assistance of a technician if the user is unaware about i have just finished working on one today and that is what i replaced. Exchange this print cartridge with a new one.If the control panel still shows the error message, 54.2, the print cartridge that was removed is working. Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video,

works great. Piliin ang iyong wika. I have found lots of ink cartridges, transfer kits, drum kits, and fusers at bargain prices as companies upgrade and those items become surplus. by unknown on Jul 6, 2004 at 3:55pm Add comment Please sign in to comment 0 I would check the cable going to the corousel motor.

The issue can troubleshoot using the technique mentioned below. I was one until about 2 years ago and just recently discovered this old document cached on my laptop that I used to take with me on service calls. I removed top and side covers but I could not find it anywhere ... by Anonymous on Jul 25, 2007 at 3:23pm Add comment Please sign in to comment 0 As a continuation of my post directly above, the only common anomaly between the printers

Touch Cartridge Rotate to rotate the carousel to the next print cartridge, and then repeat the previous steps to replace the print cartridge.CAUTION: Wait until the rotation sounds stop before you By using this site, you accept the Terms of Use and Rules of Participation Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! Generated Thu, 29 Sep 2016 22:47:23 GMT by s_hv977 (squid/3.5.20) was curious to how u reset the format board to get urs back working again?may email me direct to [emailprotected] thanks - Anonymous 0 well I was able to get the

I had someone bring in one of these for repair with same issue. Before the carousel rotates it has to rotate that piece so that the highest section (the part that sticks out) is up. But now it works again, for now. Respond to this 1 When it moves backwards and sticks does it make a grinding noise?Its probably something physical on the inside of the carousel, like some bearings or something that

© Copyright 2017 postmapper.com. All rights reserved.